How to Remove White-Out (Correction Fluid) Stains from Clothes?

 
Test Fabric for Colorfastness
 

• Before applying any solvent, test on a hidden area of the fabric to ensure it won’t cause discoloration or damage.
• Apply a small amount of the chosen solvent and let it dry to check for adverse reactions.

• Carefully scrape off as much of the dried white-out as possible using a blunt knife or spatula.
• Be gentle to avoid pushing the white-out deeper into the fabric fibers.

• Use isopropyl alcohol (70% or higher) or a non-acetone nail polish remover if your fabric is acetone-resistant.
• Dampen a clean cloth or cotton ball with the solvent and gently dab it onto the stain.
• For newer stains, this will help to break down the correction fluid’s polymers and solvents.

• Use a clean, white cloth or paper towel to blot the area. Avoid rubbing to prevent the stain from spreading.
• Periodically replace your blotting cloth to prevent re-depositing the white-out into the fabric.

• After treating the stain, rinse the fabric under cold running water.
• This helps remove both the solvent and any loosened particles of the white-out.

• If the stain persists, repeat the application of the solvent and blotting process several times.
• Persistent stains may require gentle agitation with a soft brush, but use caution to avoid fabric damage.

• Once most of the stain is removed, launder the garment as per the care label instructions.
• Use a heavy-duty detergent to help remove any residual solvent and stain particles.
• Air dry the garment to ensure that any remaining stain is completely gone before using a dryer, as heat could set any remaining traces.

• Always handle solvents in a well-ventilated area and use gloves to protect your skin.
• Avoid using high heat on fabrics until you are sure the stain has been completely removed.
• Regularly check for residual marks before proceeding with further laundry processes to avoid setting the stain.